Patton electronic 1004 Specifications, Transmission Format Asynchronous, Transmit Level 0 dBm

APPENDIX A

SPECIFICATIONS

Transmission Format: Asynchronous

Data Rate: Up to 115,200 bps

Transmit Line: 2, 4 wire unconditioned twisted pair

Transmit Mode: Full or half duplex

Transmit Level: 0 dBm

Range: Up to 9 miles

Control Signals: In DCE mode, DSR turns “ON” immediately after the terminal raises DTR; DCD turns “ON” after recogniz ing the receive signal from the line; CTS turns on after the terminal raises RTS

Carrier: The carrier is switch selected either continuous operation or switched operation, controlled by RTS

Surge Protection: 600W power dissipation at 1 mS and response time less than 1.0 pS

Power: No external power required, uses ultra low power from EIA data and control signals

Size: 2.66” x 2.10” x 0.73”

APPENDIX B

RS-232 PIN CONFIGURATIONS

DIRECTION		“DCE” SETTING		DIRECTION
			1- (FG) Frame Ground
			2- (TD) Transmit Data	To Model 1004
			3- (RD) Receive Data	From Model 1004
			4- (RTS) Request to Send	To Model 1004
			5- (CTS) Clear to Send	From Model 1004
			6- (DSR) Data Set Ready	From Model 1004
			7- (SG) Signal Ground
	To Model 1004	Data Term. Ready (DTR) - 20
			8- (DCD) Data Carrier Detect	From Model 1004

DIRECTION		“DTE” SETTING		DIRECTION
			1- (FG) Frame Ground
			2- (TD) Transmit Data	From Model 1004
			3- (RD) Receive Data	To Model 1004
			4- (RTS) Request to Send	From Model 1004
			5- (CTS) Clear to Send	To Model 1004
			6- (DSR) Data Set Ready	To Model 1004
			7- (SG) Signal Ground
From Model 1004	Data Term. Ready (DTR) - 20
			8- (DCD) Data Carrier Detect	To Model 1004

15 16