Philips LX3600 Getting Started, Inserting batteries into the remote control, Setting the TV

Getting Started

Step 1: Inserting batteries into the remote control

3

1

2

1Open the battery compartment.

2Insert two batteries type R06 or AA, following the indications (+-) inside the compartment.

3Close the cover.

Using the remote control to operate the system

Step 2: Setting the TV

IMPORTANT!

Make sure you have completed all the necessary connections. (See page 13 “Connecting TV”).

1Press SOURCE control until “DISC” appears on the display panel (or press DISC on the remote).

2Turn on the TV and set to the correct video-in channel. You should see the blue Philips DVD background screen on the TV.

3 Usually this channel is between the

lowest and highest channels and may be

called FRONT,A/V IN, or VIDEO. See

your TV manual for more details.

➜ Or, you may go to channel 1 on your

TV, then press the Channel down button

repeatedly until you see the Video In

E n g l i s h

1Aim the remote control

directly at the remote sensor (iR) on the front panel.

2Select the source you wish

to control by pressing one of the source select buttons on the remote control (for example TV,TUNER).

3 Then select the desired function (for example ÉÅ, S, T).

OPEN/CLOSE PLAY/PAUSE

IR SOURCE PREV

channel.

➜ Or, the TV remote control may have a

button or switch that chooses different

video modes.

➜ Or, set the TV to channel 3 or 4 if you

are using an RF modulator.

CAUTION!

–Remove batteries if they are

exhausted or if the remote is not to be used for a long time.

–Do not use old and new or different types of batteries in combination.

–Batteries contain chemical substances, so they should be disposed of properly.

19

001-046_LX36_17_Eng	19	3139 115 22851
		29/08/2003, 2:45 PM