dLoop Timeout
The Loop Timeout setting can be set to one of the following:
00:05 = | five minutes |
00:10 = | ten minutes |
00:15 = | fifteen minutes |
00:30 = | thirty minutes (default setting) |
00:45 = | |
01:00 = | one hour |
01:30 = | 90 minutes |
02:00 = | two hours |
03:00 = | three hours |
NEVER = | |
| intervention. |
fSet to Default Configuration
You may set the Model 2715 to its factory default configuration, except for the header lines and the password, by executing the Set to Default Configuration command.
gService Information
If you need to contact us for help, you can view the Service Information screen. Here is what it looks like:
4.0 INSTALLATION
The Model 2715 is equipped with DTE, network, and power interfaces. This section briefly describes connection to each.
4.1 DTE INTERFACE CONNECTION
The DTE interface is a V.35 DCE presented as an M/34 male connec- tor. This interface is designed to plug directly into a DTE interface (See Appendix D for V.35 interface pin assignments).
4.2 NETWORK INTERFACE CONNECTION
The Network Line Interface is an eight position keyed modular jack configured as a
| 1 | RX Data (TIP) | |
1 | 2 | RX Data (RING) | |
3 | (no connection) | ||
2 | |||
3 | 4 TX Data (TIP) | ||
4 |
|
| |
55 TX Data (RING)
6 | 6 (no connection) |
7 | |
8 | 7 (no connection) |
8 (no connection)
Figure 3. Model 2715 twisted pair line interface.
NOTE: If the Model 2715 is being used for private short range modem applications, the twisted pair cable connected to its port will need to be a
25 | 26 |