Patton electronic 1053 user manual Operation, Power-Up, LED Status Monitors, Led

5.0 OPERATION

Once the Model 1053 is properly configured and installed, it should oper- ate transparently. This sections describes power-up, reading the LED status monitors.

5.1 POWER-UP

Before applying power to the Model 1053, read section 4.3, “Power Con- nection” on page 12 to ensure that the unit is connected to the appropri- ate power source.

5.2 LED STATUS MONITORS

The Model 1053 features six side-panel LEDs (see Figure 7). Table 1 describes the function of each LED.

	Figure 7. Model 1053 side panel LEDs
	Table 1: LED descriptions
LED	Description
TXD	(Active: Green) When lit, indicates data transmission.
RXD	(Active: Green) When lit, indicates data transmission.
LINK	(Active: Green) When lit, indicates that the end-to-end DSL
	framer link is up, signifying that the link across the DSL span
	is active. The DSL Link LED is off when the link is down.
NS	(Active: Yellow) When the No Signal LED is lit, it indicates
	that the local Model 1053 is not connected with the remote
	Model 1053

14