Patton electronic 1053 user manual Warranty Information, FCC Information, CE Notice

Page 4

1.0 WARRANTY INFORMATION

Patton Electronics warrants all Model 1053 components to be free from defects, and will—at our option—repair or replace the product should it fail within one year from the first date of shipment.

This warranty is limited to defects in workmanship or materials, and does not cover customer damage, abuse or unauthorized modification. If this product fails or does not perform as warranted, your sole recourse shall be repair or replacement as described above. Under no condition shall Patton Electronics be liable for any damages incurred by the use of this product. These damages include, but are not limited to, the following: lost profits, lost savings and incidental or consequential damages arising from the use of or inability to use this product. Patton Electronics spe- cifically disclaims all other warranties, expressed or implied, and the installation or use of this product shall be deemed an acceptance of these terms by the user.

1.1 FCC INFORMATION

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interfer- ence when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna

Increase the separation between the equipment and receiver

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

1.2 CE NOTICE

The CE symbol on your Patton Electronics equipment indicates that it is in compliance with the Electromagnetic Compatibility (EMC) directive and the Low Voltage Directive (LVD) of the Union European (EU). A Certificate of Compliance is available by contacting Patton Technical Support.

4

Image 4
Contents User Manual Table of Contents Page FCC Information Warranty InformationCE Notice Service Tel 301 Mailsupport@patton.comGeneral Information FeaturesDescription Configuration Configuring the Hardware DIP SwitchesConfiguring DIP Switch S1 Opening the Model 1053 caseS1-4 Setting S1-3 SettingS1-1 S1-2 Sync Data Rate Async. Data Rate Configuring DIP switch S2 Other Model 1053 for receive recover clock modeS1-8 Installation Connecting the Twisted Pair InterfaceConnecting the Model 1053/A RS-232 to a DTE Device Connecting the Model 1053/A RS-232Power Connection Universal AC Power 100-240 VAC DC PowerPort at +1 301 975-1007, via our web site at For more informationPOWER-UP OperationLED Status Monitors LEDControl Signals LED Status IndicatorsConnectors PowerTemperature Range WeightAltitude HumidityAppendix B Model # DescriptionDB-25 Female Connector Pin # SignalAppendix C RS-232 InterfacePage Copyright Patton Electronics Company All Rights Reserved