Patton electronic manual Model 2977 daughter board installation

Page 37

Model 2977 DialFire RAS User Guide

3 • Installing the Model 2977 adapter

 

 

4.Remove the daughter card from its ESD protective packaging.

5.Using the screws provided, attach the four spacers to the DialFire adapter, on the side with the connector, as shown in figure 7 (below) and figure 8 on page 38. Be sure to install the spacers on the plated through- holes.

6.Plug the daughter card onto the DialFire adapter (see figure 7 and figure 8). The spacers should line up with the plated through-holes on the daughter card.

Mating

Connectors

Plated- through holes

Spacers

Screws

Figure 7. PCI Board: Installing the Daughter Card on the DialFire PTE Adapter

Model 2977 daughter board installation

37

Page 36 Page 38
Image 37
Page 36 Page 38
Contents DialFire Remote Access Server Patton Electronics Company, Inc Contents Contents Model 2977 DialFire RAS User Guide Using the Viewer Contents Model 2977 DialFire RAS User Guide Industry Canada Notice Radio and TV InterferenceFCC Information DialFire B4/ST RAS CE Notice FCC Part 68 Compliance StatementCompliance Information Model 2977 DialFire RAS User Guide Structure AudienceTypographical conventions used in this document PrecautionsGeneral conventions Mouse conventions Typographical conventions used in this document DialFire Model 2977 RAS Adapters Chapter contentsModel 2977 DialFire RAS overview IntroductionModel 2977 DialFire T1/E1 RAS Model 2977/B4 DialFire BRI RASMicrosoft Supported Operating SystemsPreparation Completing a configuration worksheet DialFire Basic BRI Configuration Worksheet Patton Electronics DialFire Channelized T1, Short-Haul Configuration Worksheet Order the Isdn Line DialFire PTE Isdn E1 Euro Isdn Configuration WorksheetNone Interface ID for Port 48 PT2 Only 127 Leased Time Slots Before You Install DialFire Isdn T1 PRI, Short-Haul Configuration Worksheet Request the following Isdn line configuration Installing the Model 2977 adapter Determining your line termination requirements Model 2977 B4 ST adapter installationDialFire BRI connectors and line-terminating DIP switch Installing the DialFire RAS B4ST AdapterReplace the computer’s cover Model 2977 B4 U adapter installationDialFire BRI connectors PE1 & PE2 Connector Locations Model 2977 PE1 PE2 adapter installationPT1 & PT2 Connector Locations Model 2977 PT1 PT2 adapter installationParts List Model 2977 daughter board installationInstallation Model 2977 daughter board installation Plated-through holes Spacers Screws Mating Connectors Driver installation Configuration Driver installation and configuration Procedure Driver installation for the Windows 2000 operating systemSupported Products RequirementsUpgrading the Driver Installing the DriverDriver installation for the Windows XP operating system Configuring Incoming Dial-up Networking Connections Additional NotesChanging Adapter Properties Configuring Outgoing Dial-up Networking ConnectionsChanging Phone and Modem Options Using the Windows Troubleshooter Uninstalling the DriverInstalling the Driver CD Installing the MS Loopback Adapter Installing the Driver DownloadedChanging the Adapter Configuration Configuring the Adapter First TimeConfiguring RAS Ports Configuring RAS Dial-in Permissions Configuring Modems on COM Ports Configuring Dial-up Networking ConnectionsChanging Serial Port Names Page Using the Viewer Starting Patton View About Patton ViewOperation and shutdown De-activating the Model Activating the Model
Related manuals
Manual 59 pages 22.92 Kb
Top Page Image Contents