OnSite Model 2884 User Manual | 3 • OnSite installation |
|
|
Connecting the power supply
The 2884 has the option of an internal or external Internal AC Power Supply, or an internal or external Exter- nal DC Power Supply.
Internal AC Power Supply.
•Do not connect power to the AC Mains at this time.
• There are no
WARNING tion of the Model 2884. Contact Patton Electronics Technical support at
•The internal power supply automatically adjusts to accept an input voltage from 100 to 240 VAC (50/60 Hz).
Verify that the proper voltage is present before plugging the power cord into the receptacle. Failure to do so could result in equipment damage.
1.Insert the female end of the AC power to the mains port.
120- |
|
|
240V,Power |
|
|
50/60 | Hz, |
|
| 1A | |
|
|
Power
T1/E1
T1/E1
Ports
ETH 0
ETH 1
RESET button
Reset | Console |
| |
| RS- |
| 232 |
Console
Figure 5. 2884 rear panel
2.Verify that the AC power cord included with your router is compatible with local standards. If it is not, refer to “Contacting Patton for assistance” on page 32 to find out how to replace it with a compatible power cord.
3.Connect the male end of the AC power cord to an appropriate AC power outlet.
|
|
| Model 2884 IpLink |
|
|
| T1/E1 Channelized Gigabit Router |
Port | 0 | Port | 1 |
|
|
Power
Figure 6. Power LED
4.Verify that the green Power LED is lit (see figure 6).
Installing the OnSite 2884 | 25 |