TP-Link TL-WPA4220, TL-WPA2220 manual FCC Statement, CE Mark Warning

Page 3

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/ TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1)This device may not cause harmful interference.

2)This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: The manufacturer is not responsible for any radio or tv interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.

FCC RF Radiation Exposure Statement:

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.

“To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile Configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.”

CE Mark Warning

This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

Image 3
Contents REV1.0.0 1910010839 Copyright & Trademarks CE Mark Warning FCC StatementSafety Information Yang Hongliang Product Manager of International Business Declaration of ConformityImportant Safety Instructions Contents Package Contents IntroductionSystem Requirement Conventions Before You Begin Hardware ConnectionLEDs Name Status Indication LED IndicatorDescription Connecting to the InternetPhysical Interface Hardware ConnectionConnecting the Computer Page Wi-Fi Clone Button for Super Range Extension Wi-Fi Clone StepsAfter Wi-Fi Clone Page Configure the Device LoginFor Wired Connection Management Utility Login Windows For Wireless ConnectionStatus StatusNetwork WirelessWireless Settings Wireless menuWireless Security 10 Wireless Security ¾ WPA/WPA2 Select WPA/WPA2 based on Radius Server Wireless MAC Filtering To modify or delete an existing entry To set up an entry, follow these instructionsWireless Advanced Wireless Statistics Powerline Network SettingsStation Settings Page System Tools Firmware UpgradeTo upgrade the devices firmware, follow these instructions Backup & Restore Factory DefaultsPassword RebootSystem Log Windows Connecting to Wireless NetworkInput the network key and then click OK Windows Vista Input the network key and then click OK Windows XP Input the network security key and then click Next Page Pair Buttons Setting Up a Powerline Network with the Pair ButtonCreate a Powerline network using the Pair button: Join an existing Powerline NetworkLeave an existing Powerline Network ResetEthernet LED does not light up Appendix a Troubleshooting GuidePower LED does not light up Powerline LED does not light upAppendix B Specifications