TP-Link TL-WA860RE manual Wireless Advanced

TL-WA860RE300Mbps WiFi Range Extender with Power Outlet Pass-through

Click the Enable All button to make all entries enabled

Click the Disable All button to make all entries disabled.

Click the Delete All button to delete all entries

Click the Next button to go to the next page and click the Previous button to return to the previous page.

For example: If you desire that the wireless station A with MAC address 00-0A-EB-00- 07-BE is able to access the device, while all other wireless stations cannot access the device, you should configure the Wireless MAC Address Filtering list by following these steps:

1.Click the Enable button to enable this function.

2.Select the radio button: Deny the stations not specified by any enabled entries in the list to access for Filtering Rules.

3.Delete all or disable all entries if there are any entries already.

4.Click the Add New... button and enter the MAC address 00-0A-EB-00-07-BE in the MAC Address field, enter Wireless Station A in the Description field and select Enabled in the Status pull-down list. Click the Save button.

The filtering rules that configured should be similar to the following list:

Note:

If you enable the function and select the “Deny the stations not specified by any enabled entries in the list to access” for Filtering Rules, and there are not any enabled entries in the list, thus, no wireless stations can access the device.

4.5.4 Wireless Advanced

Selecting Wireless > Wireless Advanced will allow you to do some advanced settings for the device in the following screen shown in Figure 4-17.Since the configurations are almost the same in either operation mode, here we just take that in Range Extender mode 1 for example.

Figure 4-17 Wireless Advanced

22