TL-WR642G
108M Wireless Router User Guide
¾Region - Select your region from the
The default region is United States. When you select your local region from the
)Note:
Some regions may not use 108Mbps Mode since the operation for the wireless interface in 108Mbps Mode is illegal. Limited by local law regulations, version for North America does not have region selection option.
¾Channel - This field determines which operating frequency will be used. It is not necessary to change the wireless channel unless you notice interference problems with another nearby access point.
¾Mode - Select the desired wireless mode. The options are:
•108Mbps (Dynamic) - Super G™, 802.11g and 802.11b wireless stations can connect to the router.
•108Mbps (Static) - Only Super G™ wireless stations can connect to the router.
•54Mbps (802.11g) - Both 802.11g and 802.11b wireless stations can connect to the router.
•11Mbps (802.11b) - Only 802.11b wireless stations can connect to the router.
)Note:
The default is "54Mbps (802.11g)", which allows both 802.11g and 802.11b wireless stations to connect to the router.
¾Enable Wireless Router Radio - The wireless radio of this Router can be enabled or disabled to allow wireless stations access. If enabled, wireless stations will be able to access the router. Otherwise, wireless stations will not be able to access.
¾Enable SSID Broadcast - If you select the Enable SSID Broadcast checkbox, the Wireless Router SSID will broadcast its name (SSID) on the air.
¾Enable Bridges - If you select Enable Bridges, you can communicate with the other APs in bridge mode by entering their MAC addresses. For example: If you want to communicate with the remote AP whose MAC address is
30