TP-Link TL-SG2424, TL-SG2452, Tl-SB2216 manual Rear Panel

Gigabit Smart Switch

LED	Status		Indication
		On	A 1000Mbps device is connected to the corresponding
	Green		port, but no activity
10/100/		Flashing	Data is being transmitted or received
1000Mbps		On	A 10/100Mbps device is connected to the corresponding
	Yellow		port, but no activity
		Flashing	Data is being transmitted or received
	Off		No device is connected to the corresponding port

10/100/1000Mbps RJ45 Port

Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or 1000Mbps. Each has a corresponding 1000Mbps LED.

SFP Port

Designed to install the SFP module. TL-SG2452 features 4 individual SFP ports.

Reset

Press this button for five seconds or above to reset the software setting back to factory default settings.

Port Feature

Model	10/100/1000Mbps RJ45 Port	SFP Port
TL-SG2216	16	2
TL-SG2424	24	4
TL-SG2424P	24	4
TL-SG2452	48	4

Note: For TL-SG2216/TL-SG2424/TL-SG2424P, when using the SFP port with a 100M module or a gigabit module, you need to log on to the GUI (Graphical User Interface) of the Switch and configure its corresponding Speed and Duplex mode on Switching→Port→Port Config page. For 100M module, please select 100MFD while select 1000MFD for gigabit module. By default, the Speed and Duplex mode of SFP port is 1000MFD. TL-SG2452 supports 1000M SFP module connection only.

Rear Panel

The rear panel of TL-SG2216 is shown as the following figure.

Grounding Terminal

Power Socket

FFFFFFFFFFF Rear Panel of TL-SG2216

Introduction 05