Polycom 4300T manual Routing Information

Page 73

System Diagnostics

To view the networking configuration and status of the 4300T proceed to the Network Information page as follows:

1.Select System.

2.Select System Overview.

3.Select Network Information.

The following networking information is displayed:

Routing Information

The system routing table contains the static routes for hosts and networks that are configured on the 4300T. If just the LAN and WAN IP addresses have been configured there will be four lines displayed:

•The private subnet will be associated with the LAN interface.

•A public subnet present for the WAN interface.

•An entry for the 4300T loopback interface

•The 4300T’s default gateway forwarding to the WAN interface

Additional lines may be displayed depending on the contents of the Route and VoIP Subnet Routing pages. Each of the entries on these pages will cause an additional entry in the routing table.

Link Status

Link Status displays the status of the ethernet interfaces. Ethernet autonegotiation is often unreliable, especially between different vendors or old and new networking equipment. Failure of autonegotiation is generally not a cause for concern. However, if the negotiated rates change intermittently or the link is reported as down or no link, the link rate may need to be set manually on the Set Link Rate page. Intermittent data and voice outages may be caused by link flapping when the two endpoints of the Ethernet cable cannot reach agreement using autonegotiation". If the link rate is set manually, ensure that the device at the far end of the connection can communicate at the desired rate. Incompatible rates can cause a loss of communication with the 4300T.

Link status for the Ethernet ports is displayed via the LEDs adjacent to each physical port.

Interface Information

The specific status and configuration information for the system interfaces is displayed in the Interface Information section. HDLC0 shows the interface statistics for the T1/E1 WAN link. ETH0 shows the interface statistics for the internal LAN interface between the 4300T processor and the built-in LAN switch. Interface statistics for the external LAN ports are not displayed.

4 - 3

Page 72 Page 74
Image 73
Page 72 Page 74
Contents User Guide V2IU 4300T Converged Network Appliance Trademark Information Contents User Guide V2IU 4300T Converged Network Appliance System Diagnostics Upgrading the 4300T Saving and Restoring the 4300T ConfigurationContents User Guide V2IU 4300T Converged Network Appliance Quality of Service T1 Wide Area Network WAN Access Router4300T Converged Network Appliance SecurityCall Quality Monitoring Feature SummaryFuture-proof Scalability LED Label Activity Description Front Panel LEDsBack Panel Power ConnectorErase Button Management console portEthernet WAN port T1/E1 WAN portUser Guide V2IU 4300T Converged Network Appliance Desktop Installation Physical InstallationWall-Mount Installation Administration of the 4300T Getting Started User Guide V2IU 4300T Converged Network Appliance Configuring the 4300T Configuration Guide For IP Centrex Applications Task Subtask Configure For IP Centrex Application? Configuration OutlineUser Guide V2IU 4300T Converged Network Appliance Configuration Guide For Station Side IP PBX Applications Configure For Station Configuration Guide For Trunk Side IP PBX Applications Task Subtask Configure For Trunk Side IP PBX Application? Configuration Guide For Hosted Video Applications Configure For Hosted Configuration Guide For Enterprise Video Applications Configure For Hosted Configure the LAN Interface System ConfigurationPress Submit Configuring the 4300T Modify an Existing Vlan Configuration Configure the WAN Interface User Guide V2IU 4300T Converged Network Appliance Frame Relay Mode and Dlci Configure the Dhcp Server Mask Select Dhcp Server Uncheck the Enable Dhcp Server checkbox Configure Hostname, Snmp and Remote Logging Disable Snmp Configure a local Hostname Change the Administration Password VoIP ConfigurationConfigure the VoIP ALG Performs a Tftp server relay function Configure VoIP Subnet Routing Enter a VoIP Subnet Route Configure IP Phones, IADs or Softphones NAT for Data Traffic Data Networking ConfigurationProtocolPublicIPAddress/netmask-portPrivateIPAddress-port Static IP routing Firewall Configuration Enable or disable the firewall Action Description Input format Traffic Management Configuration Enable Traffic Shaping Enable CAC Optionally enable priority IP addressesCloser Look at Traffic Management in the 4300T Upstream Traffic Management ClassifyingDownstream Traffic Management Key benefits and features of VoIP survivability VoIP Survivability ConfigurationHow survivability works Platform Support Configuring VoIP Survivability in V2IU AppliancesEnable VoIP Survivability Specify the number of digits to use for local dialing Configuring the 4300T Configure call processing server redundancy Configuring the 4300T User Guide V2IU 4300T Converged Network Appliance System Diagnostics Viewing Networking Information Viewing the ALG registration codeRouting Information Viewing Advanced System Information Passive Voice Call Monitoring Accessing Troubleshooting ToolsVerify Registered Voice and Video Devices Performing a Ping Test Restarting Networking Processes Ewn Command Saving and Restoring the 4300T ConfigurationCopy a Backup File to a Remote Tftp Server Create a Backup File and Save in Local FlashDownload a Backup File from a Remote Tftp Server List the Available Backup FilesDelete a Backup File User Guide V2IU 4300T Converged Network Appliance Upgrading the 4300T Upgrade Procedure for Software Revision 1.3.11 or LaterUser Guide V2IU 4300T Converged Network Appliance Appendix Troubleshooting TipsSpecifications Example Neighboring Path Navigator Gatekeeper supportCloud Configuration Neighboring Gatekeeper Neighbors Add Endpoints Path Navigator On the Path Navigator GK A, setup two Neighboring Gatekeeper Network Settings VoIP ALG H323 Settings Appendix Configuration -- Neighboring Gatekeeper -- Neighbors -- Add Network Settings VoIP ALG H323 settings Appendix V2IU C VoIP ALG H323 Settings User Guide V2IU 4300T Converged Network Appliance Appendix Endpoints Path Navigator Regulatory Notices Other Rights and Limitations Regulatory Notices Warranty and Warranty Exclusions Regulatory Notices Miscellaneous Regulatory Notices User Guide V2IU 4300T Converged Network Appliance Regulatory Notices User Guide V2IU 4300T Converged Network Appliance FCC Part 15 Notice Industry Canada IC Notice Warranty and Repair Service Center

4300T specifications

The Polycom 4300T is an innovative communication device designed for businesses seeking reliable and high-quality audio conferencing solutions. As part of Polycom's renowned lineup of voice communication products, the 4300T delivers superior sound quality, making it an essential tool for any professional environment.

One of the standout features of the Polycom 4300T is its Acoustic Fence technology, which effectively eliminates background noise, allowing participants to focus on the conversation without distractions. This feature is particularly beneficial in open office settings where ambient noise can be a significant barrier to clear communication.

The device is designed with a user-friendly interface, making it accessible for users of all levels of tech-savviness. Its intuitive controls and easy-to-read display facilitate seamless operation during meetings, ensuring that users can engage in discussions effortlessly. Additionally, the 4300T boasts a multi-device connectivity capability, allowing it to connect easily with various devices such as smartphones, tablets, and computers via Bluetooth and USB.

Another remarkable characteristic of the Polycom 4300T is its exceptional audio quality achieved through the use of Wideband technology. This allows for crystal-clear voice transmission, making conversations more natural and easy to follow. The device also features a built-in speakerphone, which adds to its versatility, allowing for hands-free communication in smaller conference rooms or personal office spaces.

The 4300T supports both SIP and H.323 protocols, enabling compatibility with a wide range of communication systems and platforms. This flexibility is crucial for organizations that utilize different software and hardware for their communication needs, as it simplifies integration into existing infrastructures.

Moreover, the Polycom 4300T is built to deliver durability and longevity. Its robust design ensures that it can withstand the rigors of daily use in busy corporate environments. The device is also energy-efficient, making it an environmentally friendly choice that helps businesses save on energy costs.

In conclusion, the Polycom 4300T is a formidable audio conferencing solution that combines advanced technologies, user-friendly features, and durability. Its Acoustic Fence technology, exceptional audio quality, multi-device connectivity, and compatibility with various protocols make it an invaluable asset for businesses aiming to enhance their communication capabilities. Investing in the Polycom 4300T ensures that organizations can conduct clear, effective meetings, fostering collaboration and productivity among teams.
Top Page Image Contents