Version | Polycom AP-8, AP-7, AP-6 specification

Avaya AP-6, AP-7, AP-8 Access Points

Access Point Configuration

(Version 2.52)

1.Connect to the AP via Netscape or Internet Explorer by navigating to the URL http://<IP_Addr> (where <IP_Addr> is the IP address of the AP).

2.From the main page, click on the Configure link.

3.To configure WEP settings, obtain the key values from the local network administrator and use the Avaya AP-6, AP-7, or AP-8 User Guide for guidance in programming the encryption settings. The WEP configuration screen is reached from the main menu by clicking on Configure, followed by SSID/VLAN/Security, followed by

Security Profile

Note that the handsets must each be configured manually with the identical WEP settings.

4.Click Configure, then click the Interfaces link and choose the appropriate radio (Slot A or Slot B) to configure.

5.From the Interfaces tab, confirm that the RTS/CTS Medium Reservation Threshold is greater than 600 or disabled.

6.Set the Transmit Rate field to 11Mb/s.

7.From the Filtering tab, select the Advanced tab. Enable the Proxy ARP function and disable IP/ARP Filtering.

8.The SpectraLink 8000 SVP Server is disabled by default in the Avaya AP-6, AP-7, and AP-8 access points. To enable SVP, select the QoS tab. Select the Enable Quality of Service check box to enable SVP.

9.Conditional: If you are not using a SpectraLink 8000 SVP Server and intend to use 802.11b/g mode, it is necessary to use the command line interface (CLI). The CLI is available through both the serial port interface and over the Ethernet interface using a Telnet session.

a.Once in the CLI, enter:

set speclinklegacysupport enable

b.To ensure that SpectraLink legacy support is enabled, enter: show speclinklegacysupport

PN: 1725-36046-001_G.doc