2.4 Hardware Connection – Internet
This section describes how to connect the Powerline Adapter into your existing ADSL broadband connection via ADSL Ethernet port. Follow the procedures described below to connect the Powerline Adapter to your ADSL broadband connection:
1．Connect one end of the provided Ethernet (RJ45) cable to the Powerline Adapter’s Ethernet port.
2．Connect the other end of the Ethernet (RJ45) cable to an available Ethernet port of your ADSL
broadband Router.
3．Plug the Powerline Adapter into a wall socket next to the computer.
4．Turn on your computer.
5．Check and confirm that the Power LED 
, Ethernet LED 
, and Powerline LED Powerline Adapter are ON.
The hardware connection mechanism is shown below:
on the
)Note:
Where the MAINS plug or an appliance coupler is used as the disconnected device, the disconnect device shall remain readily operable. The idle wall sockets or electrical outlets in your household electrical circuit can be used normally without interference from the network.
8