TP-Link td-w8951nd manual FCC Statement

Page 3

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/ TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1This device may not cause harmful interference.

2This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.

FCC RF Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.

“To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile Configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.”

Image 3
Contents Rev 4.0.0 TD-W8951ND 150Mbps Wireless N ADSL2+ Modem RouterCopyright & Trademarks FCC Statement Korea Warning Statements NCC Notice & Bsmi Notice Yang Hongliang Product Manager of International Business Product Description 150Mbps Wireless N ADSL2+ Modem RouterContents Maintenance Package Contents Main Features WirelessProduct Overview Conventions LED Explanation Name Status Indication Front PanelBack Panel Installation Environment Wall-mount Install Connecting the Modem RouterTD-W8951ND150Mbps Wireless N ADSL2+ Modem Router User Guide Configure PC Quick Installation GuideTD-W8951ND150Mbps Wireless N ADSL2+ Modem Router User Guide Configure the IP address as -4shows. After that, click OK Is the TCP/IP configuration for your PC correct? LoginTD-W8951ND150Mbps Wireless N ADSL2+ Modem Router User Guide TD-W8951ND150Mbps Wireless N ADSL2+ Modem Router User Guide Click Next to finish the Quick Start Device Info StatusSystem Log Statistics Receive Receive total Bytes Statistics TableQuick Start Internet Interface SetupTD-W8951ND150Mbps Wireless N ADSL2+ Modem Router User Guide Dynamic IP Address Static IP Address PPPoA/PPPoE 2 LAN Bridge ModeTD-W8951ND150Mbps Wireless N ADSL2+ Modem Router User Guide TD-W8951ND150Mbps Wireless N ADSL2+ Modem Router User Guide Wireless TD-W8951ND150Mbps Wireless N ADSL2+ Modem Router User Guide TD-W8951ND150Mbps Wireless N ADSL2+ Modem Router User Guide TD-W8951ND150Mbps Wireless N ADSL2+ Modem Router User Guide WEP-128Bits WEP-64BitsWPA2-PSK WPS Settings PBCMethod One Method Two PIN code 22 Method One Enter the PIN into my modem router Start WPSTD-W8951ND150Mbps Wireless N ADSL2+ Modem Router User Guide Firewall Advanced SetupRouting 3 NAT Virtual Server 3.1 DMZOther operations for the entries as shown in Figure To add a virtual server entryTo add a mapping rule 4 QoS TD-W8951ND150Mbps Wireless N ADSL2+ Modem Router User Guide Vlan Assign Vlan Pvid for each Interface Define Vlan Group Adsl 1 ACL Access ManagementIP Filter FilterTD-W8951ND150Mbps Wireless N ADSL2+ Modem Router User Guide To add an IP Address filtering entry TD-W8951ND150Mbps Wireless N ADSL2+ Modem Router User Guide TD-W8951ND150Mbps Wireless N ADSL2+ Modem Router User Guide To add a MAC Address filtering entry TD-W8951ND150Mbps Wireless N ADSL2+ Modem Router User Guide To add a URL filter entry 2.4 URLUPnP SnmpDdns Cwmp Maintenance AdministrationTime Zone PC’s Clock NTP Server automaticallyManually FirmwareTo back up the modem router’s current settings To restore the modem router’s settings SysRestart DiagnosticsHelp TD-W8951ND150Mbps Wireless N ADSL2+ Modem Router User Guide Physical and Environment GeneralT2. What can I do if I don’t know or forget my password? Appendix B TroubleshootingClick Network Connections Connection Click PropertiesProtocol TCP/IP Click OK TD-W8951ND150Mbps Wireless N ADSL2+ Modem Router User Guide Double-click Internet Area Connection Click Properties TD-W8951ND150Mbps Wireless N ADSL2+ Modem Router User Guide Click Internet Options Select Never dial a connection T4. What can I do if I cannot access the Internet?TD-W8951ND150Mbps Wireless N ADSL2+ Modem Router User Guide Appendix C Technical Support