TP-Link tl-wps510u manual TL-WPS510U Pocket-Sized Wireless N Print Server

TL-WPS510UPocket-Sized Wireless N Print Server

14.Enter the “Internet Protocol (TCP/IP) Properties” page as shown in Figure 3-31.Fill in the following parameters.

¾IP Address: Specify an IP address for your adapter. The IP address must be within the same subnet as your wireless router or access point. For example, if the LAN IP address of your wireless router or access point is 192.168.1.1, the IP address should be set to 192.168.1.X (1<X<10 or 10<X255, for 192.168.1.10 has been specified for your print server). Here we take 192.168.1.101 for example.

¾Subnet Mask: Enter the subnet mask of your network.

¾Default Gateway: Enter the LAN IP address of your wireless router or access point. Here takes 192.168.1.1 for example.

Figure 3-31

15.Log into the web management page of the print server again. Select “Setup”, and then choose “Wireless”. Configure the following wireless parameters.

¾Network Type/ SSID /Channel: select the network (Take TP-LINK_A4161E for example) from the “Site Survey” list and then these three fields will be automatically filled.

¾Transmission Rate: Keep the default value.

¾Wireless Mode: Keep the default value.

¾Security Type: Select the security type of your wireless router (TP-LINK_A4161E) and then enter the key. Here we take WPA-PAK security type with 1234567890 as the key for example.

23