Prestige 964 Cable Router
2.3Factory Default Settings
The Prestige is configured as a IP sharing router with NAT and DHCP enabled and with following factory default.
| Table | |
|
|
|
Items |
| Settings |
LAN IP Address |
| 192.168.1.1 |
|
|
|
Subnet Mask |
| 255.255.255.0 |
|
|
|
DHCP IP Pool |
| 192.168.1.33 – 192.168.1.64 |
|
|
|
Web username |
| user |
|
|
|
Web password |
| 1234 |
|
|
|
The default might be different from different cable operators. Please consult with your cable Internet service provider for any change.
2.4Initializing the Cable Sharing Gateway
This section outlines how to connect your Prestige to the LAN and the cable network.
Step 1. Preparing the CATV Coaxial Cable Connection
Locate the coaxial cable at the installation site and move the cable end, or install a
Step 2. Connecting the Prestige to the Cable System
Connect the Prestige to the cable port using an
Step 3. Connecting Ethernet Cable(s) and/or USB cable to the Prestige
If you do not have an Ethernet interface card (NIC) in your computer, please install one or use the USB connectivity. The Ethernet interface of your Prestige support 10/100M
Step 4. Connecting the Power Adapter to your Prestige
Connect the power adapter to the port labeled POWER on the rear panel of your Prestige.
Step 5. Prestige Initialization
The Prestige is powered on whenever you connect the power adapter to the power outlet. It will initialize the system and start to connect with headend CMTS. When the CABLE LED shines steadily, the Prestige is ready to handle data traffic. The first initialization process might take several minutes because it will scan for the proper downstream and upstream channels. When the P964 is ready, it will memorize the channel attributes. If
Hardware Installation |