Touch Up

Finally, realize that even though the Impulse® 100P is a very powerful and high output unit, it does ultimately have limits, and it may need additional powered units (or a subwoofer) to provide enough sound output or coverage. In this case, try turning the mixer levels down a little to see if that clears things up.

If, after checking all the listed things to check, and anything else you can think of to check safely, and the system still exhibits problems, carefully note all conditions and check with your Peavey dealer for advice.

CARE and MAINTENANCE

Your Impulse 100P is a sturdy and durable product, which will provide years of reliable use if properly cared for. Use common sense and read the safety warnings to avoid hazardous operating conditions.

The unit must be disconnected from the AC power source before any work is done on it. Refer all servicing to qualified service personnel.

Sunlight/Heat

Avoid prolonged exposure to direct sunlight, as this may cause the unit to overheat and thermally shut-off. Excessively hot operating conditions can also cause a thermal shut-down.

Do not store in extremely hot or cold conditions, or extremely high humidity. Always allow unit to come to room temperature before use.

Cleaning

Never clean the Impulse 100P while plugged in or turned on! When the unit has been fully disconnected from AC power sources, a dry cloth can remove soil or other dirt. Never use strong solvents on the Impulse 100P, as they could attack the polymer that the cabinet is made from. Do not allow ANY fluids to drip inside the Impulse 100P!

If the Impulse 100P cabinet should become scratched or abraded, it can be touched up using a black permanent marker. First, if the area to be touched up is larger than a short scratch, rub it lightly with an un-soaped plastic scrub pad. Wipe the scratched or abraded area a little at a time with the black permanent marker, and wipe away the surplus with a lint-free cloth. For an overall finish enhancement and protective coating, use gloves to apply either WD-40®or Armour-All®protectant to the surface of the plastic cabinet only. Note that the cabinet will be slippery after these treatments, rub them down vigorously with a dry lint-free cloth to minimize this.

If the grill should become discolored or show signs of a white coating, you can use a cleaner such as 409® or Fantastic® to clean this off of the grille. Use a clean cloth that is slightly dampened with the cleaner, and rub it across the front surface of the grille.

Check for Secure Hardware

After the first few months of use, and periodically thereafter, check the hardware of the Impulse 100P for tightness, including the rear panel screws, and the screws that hold the baffle and rear cabinet together. The unit is subject to a great deal of vibration, and this could cause them to be less than tight with use.