Lindy 32251 manual CPU Switch Smart SUN-MAC-PCInstallation and Use

restore lost mouse movement using the CPU Switch Smart SUN-MAC-PC's mouse restoration functions.

Mouse restoration functions should be used with care as unpredictable results may occur if the wrong mouse type is selected. If in doubt restore the mouse by powering down the PC normally.

Standard PS/2 mouse data uses a different data format to IntelliMouse data and so two reset functions are provided on the CPU Switch Smart SUN-MAC-PC. The type of data format expected by the PC depends upon the driver and the type of mouse that was connected when the driver was booted. The following table may be used as a guide.

Note that the mouse reset functions predict the likely mouse resolution settings but may not restore the speed or sensitivity of the mouse exactly as they were when the PC originally booted.

Type of mouse / system	Driver type	Likely expected	Suggested
Connected at bootup		data format	restoration
PS/2	PS/2 only	PS/2	F5
PS/2	IntelliMouse	PS/2	F5
IntelliMouse / CPU Switch Smart PS/2 only		PS/2	F5
IntelliMouse / CPU Switch Smart IntelliMouse		IntelliMouse	F6

To restore lost mouse movement on a CPU connected to the CPU Switch Smart SUN-MAC-PC:

1)Select the CPU that has lost its mouse movement

2)Press the select key on the front of the CPU Switch Smart SUN-MAC-PC for 5 seconds until ‘C’ is displayed. You are now in configure mode.

3)To restore a PS/2 mouse connection press

F 5 f

Or, to restore an IntelliMouse connection press

F 6 f

4) Exit from configure mode by typing

E f

CPU Switch Smart SUN-MAC-PCInstallation and Use Page 22