Peavey CM2208, CM2204 owner manual Balanced, Unbalanced, Channel Inputs, Input Connections

220 Watts @ 70.7 V

Outputs 220 Watts @ 8 Ohms

Class 2 Wiring 160 Watts @ 4 Ohms

Rear Panel

+ + + +

9

				9
				HPF				HPF
Ch1		-6		-6		-6		-6
	Inputs
Ch2	-	0dB	-	0dB	-	0dB	-	0dB
	Gain	x40	Gain	x40	Gain	x40	Gain	x40
Ch3		0dB		0dB		0dB		0dB
	Ch 4		Ch 3		Ch 2		Ch 1

Ch4	Output Power per Channel	Designed and manufactured in the USA by:	CAUTION	WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC
				SHOCK, THIS APPARATUS SHOULD NOT BE EXPOSED TO RAIN OR
			RISK OF ELECTRIC SHOCK	MOISTURE AND OBJECTS FILLED WITH LIQUIDS, SUCH AS VASES,
		Crest Audio, Inc.	DO NOT OPEN	SHOULD NOT BE PLACED ON THIS APPARATUS.
		Fair Lawn, NJ USA	AVIS: RISQUE DE CHOC ÉLECTRIQUE-NE PAS OUVRIR	AVIS: DANS LE BUT DE REDUIRE LES RISQUES D’INCENDIE OU
		www.crestaudio.com		DE DECHARGE ELECTRIQUE, CET APPREIL NE DOIT PAS ETRE
			MOUNT IN RACK ONLY.	EXPOSE A LA PLUIE OU A L’HUMIDITE ET AUCUN OBJET REMPLI
			INSTALLER SUR SUPPORT DE MONTAGE SEULEMENT.	DE LIQUIDE, TEL QU’UN VASE, NE DOIT ETRE POSE SUR CELUI-CI.

(9) Channel Inputs

Ch		Inputs
Gain 4		-
		-6
0dB	0dB x40

Balanced

The inputs are balanced, three-pin Phoenix connectors. Connect the incoming signals to the respective positive (+), negative (-) and ground ( ) terminals as indicated on the unit. Channel input sensitivity is 0dBu (0.775V) when the 0dB gain setting is selected. This equates to a gain of 90.3x. Gain can also be decreased to x40 with the gain setting switch (see # 12 Gain Select). If using bridged, see the Bridged Mode section.

Input Connections

The Phoenix connectors are wired as: Pin 1 is positive; Pin 2 is negative; and Pin 3 is chassis ground. Normally balanced inputs are wired using two-conductor shielded cable as shown in the following diagram. For un- balanced (single-ended) inputs‚ the single conductor is wired to Pin 1 and the shield is connected to Pins 2 & 3 as shown in the following diagram.

Ch		Inputs
Gain 4		-
		-6
0dB	x40	0dB

Unbalanced

13