KTI Networks KGS-2404 Starting 24-Port GbE Web Smart Switch Up, Hardware and Cable Installation

2. Installation

2-1. Starting 24-Port GbE Web Smart Switch Up

This section describes how to install the Web Smart Switch and its components, and also includes the following information:

-Hardware and Cable Installation

-Management Station Installation

-Software booting and configuration

2-1-1. Hardware and Cable Installation

At the beginning, please do first:

⇒Wear a grounding device to avoid the damage from electrostatic discharge

⇒Be sure that power switch is OFF before you insert the power cord to power source

•Installing Optional SFP Fiber Transceivers to the 24-Port GbE Web Smart Switch

Note: If you have no modules, please skip this section.

Fig. 2-1 Installation of Optional SFP Fiber Transceiver

•Connecting the SFP Module to the Chassis:

The optional SFP modules are hot swappable, so you can plug or unplug it before or after powering on.

1.Verify that the SFP module is the right model and conforms to the chassis

2.Slide the module along the slot. Also be sure that the module is properly seated against the slot socket/connector

3.Install the media cable for network connection

4.Repeat the above steps, as needed, for each module to be installed into slot(s)

5.Have the power ON after the above procedures are done

8