KTI Networks 2028 manual Setting the Configuration Switches

Page 14

2.5 Setting the Configuration Switches

Open the configuration switch cover on the rear of the unit. There are two switch groups as illustrated below:

Figure 2-9 Configuration Switches

The following table specifies the definition of each switch:

The M switch only functions for Port #9 and Port #10. Since Port #1 to Port #8 are fixed 10BASE-T ports, the speed of these ports is fixed at 10Mbps. No speed selection is available. D1-D8 switches are used for selecting the duplex mode for each 10BASE-T port respectively.

Port #9 and Port #10 can be configured as NWay auto-negotition ports if the M switch is set to OFF position. This setting applies to both ports at the same time. The auto-negotiation mode enables the port to negotiate a common op- eration mode with the device connected at the remote end of the link cable. The common operation mode is negotiated in the sequence as follows:

9

Image 14
Contents KTI 10/100 Fast Ethernet Switch KS2028United States 10/100 Fast Ethernet Switch Installation Guide Trademarks LED Indicators Table of Contents IntroductionInstalling the Switch Making Network ConnectionsSwitch Unit IntroductionFeatures Specifications Packing List Installing the SwitchMounting the Switch Install Rack Mount Brackets Rack MountingFront Panel and Rear Panel One 10/100BASE-TX switched port Port #9Crossover switches for Port #8 and Port #9 One expansion port slot Port #10Configuration switches Installing an Optional Port ModuleDiagnostic LED indicators 10/100BASE-TX port moduleRemove the Slot Cover Setting the Configuration Switches Factory Default Settings Port Connecting toSetting Important NoteNetwork Switched Ports Making Network Connections10BASE-T Switched Ports Straight UTP Cable 2-pair Straight UTP Cable10/100BASE-TX Switched Ports Cable Type and Maximum LengthDevice connected Duplex mode 100BASE-FX ModuleInterpretation LED IndicatorsLED Panel