KTI Networks 221TX/3 manual LED Indicators, Interpretations

Page 20

5. LED Indicators

Each Fast Ethernet adapter has three LEDs, as shown in Figure 1-2.

5.1 Interpretations

The interpretations of the LEDs are:

100Mb LED indicates an active 100Mbps connection is established.

On : Good connection between adapter and 100BASE-TX device

Off : No active connection

Blink: Not applicable

10Mb LED indicates an active 10 Mbps connection is established.

On : Good connection between adapter and 10BASE-T device

Off : No active connection

Blink : Not applicable

Activity LED indicates packets are being received or transmitted.

Blink : Network traffic is present

On : Not applicable

Off : No traffic for either speed

If you experience any problems, first make sure that the appropri- ate driver is loaded, the proper cable is connected to the connector, and the connected device complies with the adapter specifications (10 Mbps 10BASE-T or 100 Mbps 100BASE-TX). Then recheck the LED.

16

Image 20
Contents 10/100 Fast Ethernet Adapters Page Trademarks Figures Adapter Features IntroductionConnectors and LEDs Components DescriptionShows the connector and LEDs on the bracket Wake on LAN Technology Page Installing the Adapter Installing the AdapterInstalling Wake on LAN Cable Inserting the Adapter into the PCI SlotInstalling WOL Cable Connecting to the Network Mbps Connection Connecting 100BASE-TX Cable Network Driver Installation Driver InformationBios Setup Installation for Windows 98 System Check Device Manager in System Properties windowPing Command LED Indicators InterpretationsA1. Specifications AppendixAuto-negotiation Function Installing Remote Boot ROM