KTI Networks KCD-302 Series manual DC Power Jack

Page 22

DC2 + andDC2 - can be installed with another power-pair for delivering the main power input to next converter in a cascading way.

Note: Only up to four device units can be cascaded to receive power from one main power input source.

DC Power Jack
Connector:	Jack D 6.3mm	D 2.0mm

AC Power Adapters: Optional commercial rated adapters are available for purchasing.

Rated AC120V/60Hz DC7.5V 1A

Rated AC230V/50Hz DC7.5V 1A

Rated AC100V/50-60Hz DC7.5V 1A

Rated AC240V/50Hz DC7.5V 1A

Steps to apply the power to the device are:

1.Connect power adapter DC plug to the DC power jack of the converter before connecting to the AC outlet.

2. Connect the power adapter to the AC outlet.

Note: Before you begin the installation, check the AC voltage of your area. The AC power adapter which is used to supply the DC power for the unit should have the AC voltage matching the commercial power voltage in your area.

-22-

Image 22

Contents Industrial Tri-segment Media ConverterUnited States InternationalEthernet is a registered trademark of Xerox Corp Table of Contents Introduction Page Features Specifications Twisted-Pair Interface TPPort, or called copper Port Fiber Optic Interfaces FX1 Port, FX2 PortConfigurationSettingSwitchesSW LEDIndicatorsMechanical DC Power InputBasic Information EnvironmentalCertificate CE/EMCModel Specifications Optical SpecificationsAutoMDI/MDI-XFunction Far End Fault FunctionSpecial Functions Auto-negotiation FunctionInstallation UnpackingDIN-Rail Mounting Page Page Mounting on a Panel Surface Page DC Power Input Specification Applying PowerDC PowerTerminal Block DC Power Jack Making TP Port Connection Configuration SetupNetwork Cables Making FX Port Connections Configuration Switches & LED Indicators TP Port Settings SW1-SW3 Configuration Switches2 802.3x Function Setting SW4 Factory Default Settings FX Port Duplex Settings SW5 SW6Link Partner of FX Port Distance MMF cable LED Indicators LED Display Status & Interpretation