KTI Networks KCD-302 Series manual Configuration Switches, TP Port Settings SW1-SW3

3.1 Configuration Switches

SW	FUNCTION	SETTING&STATE
SW1	TP Port mode	OFF	Auto-negotiation(default)
		ON	Forcedmode
SW2	TP Port Duplex	OFF	Full duplex (default)
		ON	Halfduplex
SW3	TP Port Speed	OFF	100Mbps(default)
		ON	10Mbps
SW4	802.3x function	OFF	Enable (default)
		ON	Disable
SW5	FX1 port duplex	OFF	Full duplex mode (default)
		ON	Half duplex mode
SW6	FX2 port duplex	OFF	Full duplex mode (default)
		ON	Half duplex mode

3.1.1 TP Port Settings SW1-SW3

SW1, SW2, SW3 are used for configuring the TP port especially when connecting to a link partner port which is not auto-negotiation capable. Refer to section 2.5 for details.

3.1.2 802.3x Function Setting SW4

IEEE 802.3x function is the flow control method used for full duplex op- eration on the TP port and FX ports under store and forward mode. This method uses pause frames for one port to stop further transmission from its link partner.

-26-