7INSTALLATION
7.1Rack Mounting
The PIP-200 can be rackmounted in a standard 19" (1U) EIA rack. The machine does not require any specific spacing for ventilation above or below the unit. To mount the machine, simply place the unit's ears against the rack rails of your rack and insert standard screws through each of the four corner holes.
8CONNECTING TO VIDEO DEVICES
Video sources and output devices (such as monitors, projectors or recorders) may be connected to the PIP-200 through the BNC or 4P type connectors located on the back of the unit. Please keep in mind that the output signal format of the parent picture matches that of the input signal format.
9USING THE PIP-200
9.1Turning on the Machine
NOTES
1.The machine should only be powered on after all connections are completed and all source devices have been powered on. Do not attempt to connect or disconnect any video or control signals to the machine while it is powered on!
2.The socket-outlet should be near the equipment and should be easily accessible. To fully disconnect equipment, remove power cord from socket.
1.Press the toggle switch on the far-left front panel to the up position. The toggle switch will illuminate.
2.Operate the sources and acceptors.
9.2Setting the Internal Jumpers
The encoder's initial settings (PAL, NTSC, NTSC4.43) can be selected via internal jumpers (JMP1-JMP3) inside the machine. Only one jumper is inserted to determine which of the three ENCODER pushbuttons illuminates when the machine is turned on. If the NTSC jumper is inserted, for example, the NTSC pushbutton illuminates whenever the machine is turned on. The internal jumper locations are presented in Figure 3.
Figure 3: PIP-200 Internal Jumper locations
7
KRAMER ELECTRONICS LTD.
