Elo TouchSystems 2240L manual Monitor Mounting and Orientation

Page 16

Monitor Mounting and Orientation (continued)

Mounting to 100 mm VESA Mount—Portrait Orientation

Requires four (4) M4 thread hole Phillips head attaching screws (8 mm depth)

Note:

Dimensions are in millimeters.

Detailed mechanical drawings can be found at: www.elotouch.com

Elo TouchSystems 2240L User Guide 16

Image 16

Contents Elo TouchSystems 2240L 22-inch LCD Touchmonitor User Guide Revision B Elo TouchSystemsCopyright 2008 Tyco Electronics. All Rights Reserved Table of Contents Introduction PrecautionsAbout the Product Installation and Setup Unpacking Your Touchmonitor Check that the following items are presentConnecting the Cables to the Touchmonitor and Computer Connector Panel on Rear Side of MonitorInstalling the Touch Driver Click on Install Driver for This ComputerMonitor Overview and Dimensions IntelliTouch Model Monitor Overview and Dimensions Surface Capacitive Model Rear View of Monitor-Landscape Orientation Top Bottom Monitor Mounting and OrientationRear View of Monitor-Portrait Orientation 90º Landscape Orientation Angle ViewsPortrait Orientation Angle Views Dimensions are in millimeters Monitor Mounting and Orientation About Touchmonitor Adjustments OperationSEL select Power switch Rear Panel Control Buttons for On-Screen Display OSDSEL AUTO/SEL select OSD Remote Control ButtonsOSD Menu Functions Power Lock/Unlock Auto Adjust PhaseOSD Timeout Luminance BrightnessRecall Defaults Recall Recall ColorMiscellaneous Sharpness Display InformationPreset Display Modes Troubleshooting Solutions to Common ProblemsTechnical Support Touchmonitor Safety Care and Handling of Your Touchmonitor Waste Electrical and Electronic Equipment Weee Directive Technical Specifications Preset Display Modes 2240L SpeciﬁcationsDimensions HxWxD Regulatory Information Page Page FCC Imerc Warranty Page Getting in Touch with Elo