Elo TouchSystems AMM15TK2-TEW operation manual Ddc, Installation

DDC

To make your installation easier, the monitor is able to Plug and Play with your system if your system also supports DDC protocol. The DDC(Display Data Channel)is a communication protocol through which the monitor automatically informs the host system about its capabilities, for example, supported resolution and corresponding timing. The monitor supports DDC1 and DDC2B standard.

Installation

To install the monitor to your host system, please follow the steps as given below:

Steps

1.Use the VGA cable that provides D-SUB 15P connector and connect to the 15-pin connector on the VGA controller card.

2.Use the S-Video cable that provides S-Video connector and connector to the S- Video port on the video source device (ex. VCR, Camera system)

3.Use the BNC cable with the BNC to RAC adapter that provides composite video connector and connector to the composite video port on the video source device.

4.Use the RS-232 serial cable that provides DB9 pin connector and connect to the 9- pin connector on the source device for touch screen communication. (Optional)

5.Connect the DC power to the DC power connector on the monitor.

6.Connect one end of AC power cord into the AC Adapter and the other end to AC power outlet.

7.Then turn the computer on and then the monitor.

8.If the monitor still does not function properly, please refer to the troubleshooting section to diagnose the problem.

13