Tounchscreen User’s Manual (AMM15TK2-TE or AMM15TK2-TEW)
Quick Start
1.Connect Power Code and VGA Cable of LCD Monitor. 2.Connect Touchscreen DB9 male
4.Adjust the tilt of LCD Monitor. 5.Adjust the Picture of LCD Monitor.
6.Install driver software of Touchscreen (See “Driver software” for details). 7.Adjust the calibration of Touchscreen (See “Driver software” for details).
Introduction
The ELO IntelliTouch Touchscreen system consists of a touchscreen and an electronic touchscreen controller. The touchscreen may be a flat, spherical, or cylindrical and is installed over the face of the LCD. The touchscreen controller installed inside of theLCD.
▪The IntelliTouch Touchscreen
The IntelliTouch surface wave touchscreen consists of a glass panel molded to the precise shape of a display’s face. A
▪The IntelliTouch Controller
The IntelliTouch controllers provide the drive signal for touchscreen, convert the received analogue signals into digital touch coordinates, and send these coordinates to the computer.
Touchmonitor installation
▪Cable Connection
1.Connect and test LCD as a video display only.
2.Plug the DB9 male into the DB9 female connector labeled “TOUCHSCREEN” on the back of the LCD Monitor.
Driver software
ELO provide driver programs for the DOS, Windows, Windows NT, OS/2, and Macintosh systems. Additional drivers may be available for other system. Contact ELO for details. Installing Driver software for Windows / Windows NT
1.Shutdown Windows or Windows NT and turn off your computer.
2.Install touchscreen hardware as described in the “Quick start” or “Touchmonitor installation”.
3.Start your computer.
30