Crimestopper Security Products SV-6400 Testing the Camera Bench Testing, ClipCam Installation

Step 1: Testing the Camera (Bench Testing)

1.Prepare two sets of DC 11-13V batteries for running a bench test to make sure the camera functions are working properly (before you actually install the camera into your vehicle).

2.Refer to the wiring diagram (4.1-3) the camera and the monitor each have to have their own power source, DO NOT connect with the same battery.

3.When connecting the 20’ cable, make sure all connectors have been solidly connected.

4.Turn on the monitor and you should see a clear, color picture display.

5.If you do not see a picture or the picture quality is not satisfactory, please turn off the monitor and double check all the connectors to make sure they are securely connected.

6.Turn on the monitor again. If you are still unable to see the picture or the picture quality has not improved, contact your supplier for assistance.

Step 2: Checking the Power Source

1.The camera can only operate by connecting a power source of DC 11- 13V / 70mA type.

2.Check your vehicle and make sure you have the correct power source for the camera.

3.In most cases, the camera power line is connected with the reverse light power source.

Step 3: ClipCam Installation

1.Your package includes camera clips in two sizes. Use the size that matches with the thickness of the vehicle’s rear trunk lip. The small size clip ranges 1/4” (6 mm) and the larger size ranges from 1/4”(6 mm ) up to ½” (12 mm ) thickness.

Page 3 of 8