Dukane 28A8910 Connection to the Mouse Control, PS/2, ADB or Serial Mouse, USB Mouse, PS/2 Mouse

TECHNICAL (continued)

Connection to the Mouse Control

1. PS/2, ADB or Serial Mouse

(1)Turn off the projector and computer, and connect the two units with the appropriate cable. For PS/2 mouse control (for IBM and compatible), use the enclosed mouse cable. For others, consult your dealer.

(2)Disconnect the USB cable from the projector if it is connected. Then turn on the projector.

(3)Turn on the computer.

(4)Start the mouse function. If the mouse has not been started, reboot the computer (soft reboot or reboot buttons). Refer to the descriptions of “DISC PAD” and “MOUSE/RIGHT button” of page 4.

2. USB Mouse

(1)Connect the projector and computer with a suitable commercially available USB cable. Consult your dealer to get the cable, if you need.

(2)Start the mouse function. Refer to the descriptions of “DISC PAD” and “MOUSE/RIGHT button” of page 4.

NOTE • Before connecting, read the instruction manuals of the devices to be connected.

•In the case of notebook type computers with an internal pointing device, the mouse control function will not work unless the internal pointing device is disabled. In such case, disable the internal pointing device and change the BIOS setting to select an external mouse before the operations described in (1) to (4) above.

Also, some computers may not have a utility program to operate a mouse. Refer to the computer hardware manual for detail.

PS/2 Mouse

Projector

1 CLK 2

CONTROL Terminal	DATA 3
D-sub 15-pin shrink jack		4
		5
6117128139141015	RTS
		7
	SEL0	6
		8
	+5V	9
	GND 10
		11

12

13

14

15

Computer

1DATA

2Mouse jack

3	GND	Mini DIN 6-pin
4	+5V
5	CLK
6		6	5
		4	3
		2	1

TECHNICAL - 4