|
| Part names |
|
| Power switch (17) |
|
| AC inlet (14) |
Ports (See below.) |
| Elevator button (9) |
| Elevator foot (9) | |
|
| |
| Vent (7) | |
|
|
CONTROL port (12)
AUDIO IN2 L/R port (13) (In the default setting, the AUDIO IN2 L/R port is the audio port for the VIDEO,
COMPONENT | Y R |
| |
VIDEO ports (13) |
| ||
|
| AUDIO IN2 |
|
Y |
|
| CONTROL |
CB/PB |
|
| |
CB/PB | L | AUDIO OUT | |
CR/PR |
| AUDIO IN1 | |
CR/PR |
| ||
VIDEO port (13) |
|
| |
VIDEO |
| LINK O | |
|
| ||
| ACT O | ||
AUDIO IN1 port (12)
(In the default setting, the AUDIO IN1 port is the audio port for the RGB IN1 and RGB IN2 ports, however, it is possible to change the settings. 34)
Restart switch (*) (48) RGB IN1 port (12)
RGB IN2 /RGB OUT port (12) (Use the RGB IN OUT switch to select RGB IN2 or RGB OUT for this port.) RGB IN2 port: Inputs the RGB signal from a PC.
RGB OUT port: When connected to a monitor, outputs the signal input via RGB IN1.
USB port (12)
RGB IN1
RGB IN2 |
|
|
| USB |
| ||||
RGB OUT |
|
|
|
|
|
|
|
| |
|
|
|
|
|
K
Ports
RGB IN OUT switch (12)
Use this button to select either RGB IN2 or RGB OUT for the corresponding port. When this switch is not pushed in, RGB IN2 is selected.
When this switch is pushed in, RGB OUT is selected.
LAN Port
Used for Ethernet input/output.
This port is used when utilizing network functions.
NOTE (*) About Restart switch: This projector is controlled by an internal microprocessor. Under certain exceptional circumstances, the projector may not operate correctly and the microprocessor will need to be reset. In such a case, please push the Restart switch by using a tooth pick or similar, and before turning on again, let the projector cool down at least 10 minutes without operating. Only push the Restart switch in these exceptional instances.
5