BASIC OPERATION
TURNING ON / OFF THE PROJECTOR
TURNING ON THE PROJECTOR
1 | Complete peripheral connections (with Computer, VCR, etc.) |
before turning on the projector. (Refer to "CONNECTING | |
| PROJECTOR" on page 11~13 for connecting the equipment.) |
2 | Connect the projector's AC Power Cord into an AC outlet. LAMP |
Indicator lights red, and READY Indicator lights green. | |
3 |
|
30
Preparation Display disappears after 30 seconds.
Current image level is displayed on screen for 4 seconds.
TURNING OFF THE PROJECTOR
1 | Press POWER |
Control Unit, and a message "Power off?" appears on a screen. | |
2 | Press POWER |
LAMP Indicator lights bright and READY Indicator turns off. |
After the projector is turned off, Cooling Fans operate (for 90 seconds).
Power off?
3 | When the projector has cooled down, READY Indicator lights |
green again. |
NOTE : Projector cannot be turned on during cooling period with READY Indicator off. You can turn it on again after READY Indicator lights green.
TO MAINTAIN THE LIFE OF LAMP, ONCE YOU TURN PROJECTOR ON, WAIT AT LEAST 5 MINUTES BEFORE TURNING IT OFF.
DO NOT DISCONNECT AC POWER CORD BEFORE READY INDICATOR LIGHTS GREEN.
Message disappears after 4 seconds.
note on operation
When “Power management” function is ON, the projector detects signal interruption and turns off Projection Lamp automatically. Refer to “Power management” on page 36.
When WARNING TEMP. Indicator flashes red, the projector is automatically turned off. Wait at least 5 minutes before turning on the projector again.
When WARNING TEMP. Indicator continues to flash, follow the procedures below:
1.Press POWER
2.Check Air Filters for dust accumulation.
3.Clean Air Filters. (See "AIR FILTER CARE AND CLEANING" section on page 39.)
4.Turn the projector on again.
If WARNING TEMP. Indicator continues to flash, contact your sales dealer or service center.
19