Printing Fixed Length Labels Fixed

To print horizontal wire wraps

1. Enter the text for the label.

2.	Press	+		.
			WRAP

3.	Use the arrow keys to move to
	the desired wire gauge or
	cable size, and press .
4.	Press	Print .

123123

Figure 14

01 02 03 04 05 06

Figure 15

To print a patch panel label

1. Enter the text for the first position on the label.

Printing Fixed Length Labels FIXED

Normally, the length of the label is determined by the length of the text entered. However, you may wish to make a label for a specific purpose that is a fixed length regardless of the length of the text.

You can specify a fixed length for a label in 0.250” (6 mm) increments between 0.500” (20 mm) and 40.000” (999.9 mm). The preset fixed length is 1.5” (25 mm). Any change you make to the fixed length setting remains in effect until you change it.

The amount of text that will print on the label determines the minimum length of a label, regardless of the fixed length you set manually. For example, setting a fixed length of 0.50” for a label with 20 characters would have no effect on the label length.

To set the label length

1. Press FIXED .

2. Press	to increase the length.
3. Press	to decrease the length.

4. Press

Printing Patch Panel Labels PPANEL

Patch panel mode allows you to label a row of ports on a patch panel. You select the distance between ports, enter the desired text, serialize, and print.

The result is a long label with multiple, evenly spaced text for each port. See Figure 15.

2.	Press		.
		PPANEL

3.	Enter the distance between each label and

press . The default is 0.5” (12 mm) and the value can be set in increments of 0.5” (12 mm) up to 20” (480 mm).

4.Follow the directions in Serializing Your Labels on page 9 to serialize the text that will print on the label.

Printing Terminal Block Labels TBLOCK

Terminal block labels are very similar to patch panel labels; however, the text is printed vertically. See Figure 16.

01	02	03	04

Figure 16

To print a terminal block label

1.Enter the text for the first position on the label.

2.Press TBLOCK .

3.Enter the distance between each label and

press . The default is 0.5” (12 mm) and the value can be set in increments of 0.05” (1 mm) up to 20” (480 mm).

4.Follow the directions in Serializing Your Labels on page 9 to serialize the desired number or

letter that will print on the label.