Delta Electronics F48SA manual Mechanical Drawing, Pin No, Name, Function, Pin Specification

Page 12

MECHANICAL DRAWING

MECHANICAL DRAWING

Pin No.	Name	Function
1	-Vin	Negative input voltage
2	+Vin	Positive input voltage
3	-ON/OFF	Negative Remote ON/OFF
4	+ON/OFF	Positive Remote ON/OFF
5	+Vout	Positive output voltage
6	+Vout	Positive output voltage
7	+Vout	Positive output voltage
8	-Vout	Negative output voltage
9	-Vout	Negative output voltage
10	-Vout	Negative output voltage

Pin Specification:

Pins 3-4,	11-16	1.00mm (0.040”) diameter
Pins 1-2,	6-10	2.00mm (0.079”) diameter

All pins are copper with Tin plating.

DS_F48SA28025_12072007

12

Image 12

Contents FEATURES OPTIONSAPPLICATIONS DATASHEET DSF48SA2802512072007TECHNICAL SPECIFICATIONS INPUT CHARACTERISTICSOUTPUT CHARACTERISTICS DYNAMIC CHARACTERISTICSELECTRICAL CHARACTERISTICS CURVES 36Vin48Vin 75VinFor Negative Remote On/Off Logic For Positive Remote On/Off LogicFigure 7 Output voltage response to step-change in load Figure 12 Output voltage noise and ripple measurement test setup Figure 13 Output voltage ripple at nominal input voltage and rated load current 100 mV/div. Load capacitance470uF aluminum, 1µF ceramic capacitor and 10µFlow ESR capacitor. Bandwidth 20 MHz. Scope measurement should be made using a BNC cable length shorter than 20 inches. Position the load between 51 mm to 76 mm 2 inches to 3 inches from the module Safety Considerations Soldering and Cleaning ConsiderationsDESIGN CONSIDERATIONS Input Source ImpedanceFEATURES DESCRIPTIONS Over-Current ProtectionOver-Voltage Protection Over-Temperature ProtectionFEATURES DESCRIPTIONS CON Output Voltage Adjustment TRIMThermal Testing Setup THERMAL CONSIDERATIONSTHERMAL CURVES Thermal DeratingPin Specification MECHANICAL DRAWINGPin No NameWARRANTY PART NUMBERING SYSTEMMODEL LIST MODEL NAME