QuickSpecs
ProLiant BL20p and
Standard Features
Security | ||||
| Administrator's password | |||
| Integrated | |||
| Integrated | |||
| Interconnect Switch multilevel user names and passwords and management interface time out period setting | |||
| Up to 64 | |||
|
|
| ||
Minimum Rack Requirements | Mounts in Compaq, and Telco racks and Third Party racks that meet the following criteria: | |||
|
| • | Compatible with | |
|
| • | EIA | |
|
| • | Cabinet depth must be at least | |
|
|
| RETMA rail to rear door, inclusive in the | |
|
| • | Ample room for top and bottom cable egress (approximately 8 square inches for full rack configuration | |
|
|
| with patch panel) | |
|
| • | Must be capable of supporting 1600 lb (for full rack configuration) | |
|
| • | Perforated front and rear doors to accommodate | |
|
| • | Must have 65% open perforation on server blade enclosure doors to support airflow requirements | |
|
| • | Optimized for use with the Compaq 10000 Series racks | |
| Note: If using Compaq 7000 Series rack, Compaq Rack Extension Kit and High Air Flow Rack Door options are | |||
|
|
| required. | |
|
|
| ||
Rack Airflow Requirements | • | Rack 9000 and 10000 series Cabinets | ||
|
|
| The increasing power of new | |
|
|
| efficiency for | |
|
|
| provides enhanced airflow for maximum cooling, allowing these racks to be fully loaded with servers | |
|
|
| using the latest processors. | |
| • | Rack 7000 series Cabinets | ||
|
|
| When installing a server with processors running at speeds of 550 MHz or greater in Compaq Rack |
7000 series racks with glass doors
CAUTION: If a
oFront and rear doors: If your 42U server rack includes closing front and rear doors, you must allow 830 square inches (5,350 sq cm) of hole evenly distributed from top to bottom to permit adequate airflow (equivalent to the required 64 percent open area for ventilation).
oSide: The clearance between the installed rack component and the side panels of the rack must be a minimum of 2.75 inches (7 cm).
CAUTION: Always use blanking panels to fill all remaining empty front panel
Note: For additional information, refer to the Setup and Installation Guide or the Documentation CD provided with the server, or to the server documentation located in the Support section at the following URL:
http://www5.compaq.com/products/servers/proliantdl380/index.html.
World Wide — Version 4 — September 19, 2002 | 8 |