Installation of USB Function

The following procedure permits your computer to recog- nize or "enumerate"(A USB term) the USB HUB.

1.Power on the display monitor and then the computer.

2.Start "Enumeration" from the Windows® Desktop.

N O T E

•During the enumeration of the USB Hub, connect the keyboard and mouse, to the computer and not to the downstream ports on the display monitor. After the enumeration, the keyboard and mouse can be used by connecting to the downstream ports, if they are USB- compliant.

•Do not unplug the USB cable during the enumerations.

(1)Connect the computer and the display monitor with an USB cable. The screen below will appear.

(2)Click “Next”.

(3)Click “Finish” on the second screen to complete the enumeration of the USB HUB.

You can confirm that the USB HUB is successfully enumer- ated with the following method.

•Open “Device Manager” tab in “System” property under “Control Panel”. Confirm that “Generic USB HUB” is listed in “Universal Serial Bus Controller”. If you can’t confirm it, re-enumerate the USB HUB again by following (a) or (b).

(a)Disconnect and connect the USB cable to the up- stream port of the display monitor.

(b)Cycle power of the display monitor off then on.

N O T E

If the mark appears with “Generic USB HUB”, then enumeration was unsuccessful. Select “Generic USB HUB” marked with mark and click “Remove” and “Refresh”. After that, the enumeration is automatically started.

N O T E

The enumeration of USB HUB may be necessary for each USB port on the computer.

ENGLISH

- 3 -