Compaq 910 AC Power Connection, Signal Cable Connection, Vga, Connecting to VGA Compatible System

3INSTALLATION AND CONNECTION

17" and 19" Models

On the back of the monitor two kinds of plug-in connections are provided: AC power connector for the AC input, DB9- 15P connector for video signal input.

AC Power Connection

One end of the AC power cord is connected to the AC power connector on the back of the monitor. The other end is plugged into a properly grounded three-prong AC outlet. The monitor’s auto-sensing power supply can automatically detect 100-120V AC or 220-240V AC and 50 or 60Hz.

Signal Cable Connection

The attached signal cable provides a DB9-15P connector for the VGA compatible analog RGB outputs on your computer. The figure below shows the included signal cable connection to the Video Graphics Array (VGA) port.

1.Power off, both the monitor and the computer.

2.Connect one end of the signal cable to the DB9-15P connector on the VGA controller card.

3.Connect the other end of the signal cable to the DB9- 15P receptacle on the back of the monitor.

4.Power on the monitor, then the computer.

5.After using the system, power off the monitor, then the computer.

	Computer
	VGA
	Compatible
	System
	D-sub
	DB9-15P
Power Cord	Cable SC-B104
CAUTION

The socket-outlet shall be installed near the equipment and shall be easily accessible. During servicing, discon- nect the plug from the socket-outlet.

22" Model

On the back of the monitor three kinds of plug-in connec- tions are provided: AC power connector for the AC input, and two DB9-15P connectors for video signal input and USB ports for USB communication.

AC Power Connection

One end of the AC power cord is connected to the AC power connector on the back of the monitor. The other end is plugged into a properly grounded three-prong AC outlet. The monitor’s auto-sensing power supply can automati- cally detect 100-120V AC or 220-240V AC and 50 or 60Hz.

Signal Cable Connection	ENGLISH
ible system.
The DB9-15P(VGA) connector is provided for compatible
analog RGB outputs from your computer.
Connecting to VGA Compatible System
The figure below shows the SC-B104 cable connection to
the Video Graphics Array (VGA) port in any VGA compat-

1.Power off, both the monitor and the computer.

2.Connect the one end of the SC-B104 cable to the DB9- 15P connector on the VGA controller card.

3.Connect the other end of the SC-B104 cable to the DB9-15P receptacle on the back of the monitor.

4.Power on the monitor, then the computer.

5.After using the system, power off the monitor, then the computer.

		Computer
1	2	VGA
	3
		Compatible
	SIGNAL-A	System
		SIGNAL-B
Power Cord		Cable SC-B104
CAUTION

The socket-outlet shall be installed near the equipment and shall be easily accessible. During servicing, discon- nect the plug from the socket-outlet.

Connecting to two computers (22" Model)

The figure below shows the connection to two computers.

	Computer B
SIGNAL-ASIGNAL-B	Computer A
	VGA
Cable SC-B104

- 1 -