Circuit Breaker and ATX Switch
The circuit breaker located on the bottom panel will trip at 10 Amps nominal. The ATX switch located on this panel will energize the system when depressed. The ATX switch will also shut the unit off if depressed for approximately 3 seconds, a momentary activation should have no effect on operation.
Single Board Computer (SBC)P3/133
At the heart of the DP027010 is a P3/133 SBC with an 850 Mhz Intel Pentium III CPU. The SBC has one memory socket loaded with 512Mb of PC133 memory.
TFT Graphic Display System
The standard DP027010 military computer includes an 18.1 inch color TFT (XGA resolution 1280x1024 maximum) screen. The flat screen display has the following features:
•High Luminance
•Wide angle viewing
•A
Touch Screen
The DP027010 includes a resistive overlay touch screen on the flat panel display, which provides an efficient and reliable method of entering information. The screen responds to the touch of your finger with or without a glove.
Touch Screen Driver for Windows
The touch screen of the DP027010 is internally connected to COM1. Parameters must be set within the driver so that they match the hardware settings. If a card is installed that has settings that conflict with those of the COM 1 serial port, that card’s configuration must change. The factory default settings are:
COM Port = 1
Address = 03F8 Hex
Interrupt = 4
These parameters are written into the system registry file by the driver setup utility. The driver is installed, configured and calibrated at the time of manufacture.
System Peripherals
The DP027010 military computer system has a single hard disk drive. The drive is located on the inside of the unit. The disk drive has a standard
Jacks
This section describes the connector layout and cabling requirements on the standard DP027010 military computer. The DP027010 was designed for bulkhead mounting. The I/O ports are conveniently mounted on the bottom surface of the unit. The system has network capability by way of one Ethernet interface, which consists of two pairs of RX/TX 10 Base 2. The copper interface uses the Trompeter
Page 19
Copyright March 2003, Computer Dynamics, Inc.
All Rights Reserved