Christie Digital Systems 38-VIV210-01 Compliances, Federal Communication Commission Notice

Page 4

COMPLIANCES

Federal Communication Commission Notice

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Do not make any changes or modifications to the equipment unless otherwise specified in the instructions. If such changes or modifications should be made, you could be required to stop operation of the equipment.

CAUTION!

This is a Class A equipment. This equipment can cause interference in residential areas; in this case, the operator can be asked to take adequate countermeasures.

AC POWER CORD REQUIREMENT

The AC Power Cord supplied with this projector meets the requirement for use in the country you purchased it.

AC Power Cord for the United States and Canada :

AC Power Cord used in the United States and Canada is listed by the Underwriters Laboratories (UL) and certified by the Canadian Standard Association (CSA).

AC Power Cord has a grounding-type AC line plug. This is a safety feature to be sure that the plug will fit into the power outlet. Do not try to defeat this safety feature.

Should you be unable to insert the plug into the outlet, contact your electrician.

GROUND

 

THE SOCKET-OUTLET SHOULD BE INSTALLED NEAR THE EQUIPMENT AND EASILY ACCESSIBLE.

4

Image 4
Contents Model To the Owner Safety Instructions Compliances Federal Communication Commission NoticeTable of Contents Features and Design CompatibilityPreparation Name of Each Part of ProjectorSETTING-UP Projector Connecting AC Power CordLens Shift Adjustment Preparation Lens InstallationPositioning Projector Preparation Picture Level and Tilt Adjustment Moving ProjectorReplacement of Terminal Connecting ProjectorTerminals of Projector Connecting Projector INPUT/OUTPUT Terminals and Jacks TerminalConnecting to Computer Cables used for connectionTOP Controls and Indicators Before OperationOperating ON-SCREEN Menu HOW to Operate ON-SCREEN MenuFlow of ON-SCREEN Menu Operation Before Operation Menu BAR Screen MenuBasic Operation Turning on / OFF ProjectorTurning on Projector Turning OFF ProjectorAdjusting Screen Zoom AdjustmentFocus Adjustment Keystone AdjustmentSound Adjustment Direct OperationMenu Operation Sound MenuVideo Input Selecting Input SourceSelecting Computer System Automatic MULTI-SCAN SystemComputer Input Compatible Computer Specifications ResolutionPC Adjustment Auto PC AdjustmentPC Adjust Menu Auto PC AdjComputer Input Manual PC Adjustment Display area H Display areaFull screen Picture Image Adjustment Image Level Select DirectImage Level Select Menu Image Select MenuComputer Input Image Level Adjustment Image Adjust MenuPicture Screen Adjustment Screen MenuInput Menu InputSelecting Video System AutoAV System Menu Video or S-VIDEO AV System Menu Component VideoCinema Video Input Image Level Adjustment ColorTint Progressive scanZoom Natural wideSetting Menu SettingSetting Menu Lamp Mode Power managementOn start Remote control Key lockLamp counter reset Factory defaultAIR Filter Care and Cleaning MaintenanceAppendix Appendix Lamp Management Yellow Lamp Dim Lamp Red Lamp Mark on LampAppendix Lamp Replacement Figure shows case of replacing LampCleaning Projection Lens Order Replacement LampTroubleshooting Problem Try these SolutionsService Technical SpecificationsAppendix Configurations of Terminals HDB 15-PIN Terminal AnalogPart No -A 610 309 4632 1AA6P1P4240-- M4RK