Christie Digital Systems 38-VIV302-01 user manual Connecting Projector, Terminals of Projector

CONNECTING PROJECTOR

TERMINALS OF PROJECTOR

This projector applies various input/output terminals and 3 terminal slots for expansion to tune to diversity of signals from computers and video equipment. 3-built-in Terminal Slots enable you to arrange desired combinations of input sources just by changing Terminal Boards. For Terminal Boards, contact sales dealer where you purchased a projector.

3 TERMINAL SLOTS (Factory set)

	ANALOG RGB				AUDIO		CONTROL PORT
					R	L
						(MONO)
R/Pr	G/Y	B/Pb	H/HV	V		AUDIO	CONTROL PORT
					R	L
						(MONO)
VIDEO/Y	C		S-VIDEO		AUDIO
					R	L
						(MONO)
SERIAL PORT IN		SERIAL PORT OUT			AUDIO OUT		USB
					R	L
R/C JACK
RESET						(MONO)

INPUT/OUTPUT

TERMINALS

INPUT 3 INPUT 2 INPUT 1

HDB 15-PIN Terminal

5 BNC Terminal

AV Terminal

REPLACEMENT OF TERMINAL

NOTE; When replacement of terminal board, MAIN ON/OFF switch should be OFF position.

1	Remove 2 Screws on terminal.
2	Pull out terminal by holding handle.
3	Replace terminal. Insert terminal along Guide to fit Plug
	into Socket.
4	Tighten screws to secure terminal.

NOTES ON ORDERING OR USING OPTIONAL INTERFACE BOARD

Screws

Guide

Socket

When ordering or using Optional Interface Board (Terminal Board), contact your sales dealer. When con- tacting the sales dealer, tell the Optional Control Number (Op.cont.No.) in the menu that is located under Language Select Menu. (See page 39.)

Plug

Figure shows HDB 15-PIN terminal (Optional parts).

11