APPENDIX
OPERATING WIRELESS MOUSE
Wireless Remote Control Unit is not only able to operate this projector but also usable as a wireless mouse for most Personal Computers. POINT buttons and two CLICK buttons are used for wireless mouse operation.
This Wireless Mouse function is available only when PC mouse pointer is displayed on a projected screen. When ON- SCREEN MENU or any message / dialog box is displayed on screen instead of PC mouse pointer, this Wireless Mouse function can not be used.
INSTALLATION
To use Wireless Remote Control Unit as Wireless Mouse for a Personal Computer, installation of mouse driver (not supplied) is required. Make sure that mouse driver is properly installed in your computer. And make sure that mouse port (or USB port) of a Personal Computer is activated.
1 | Connect mouse port (or USB port) of your computer to Control |
Port (or USB connector) of this projector with Control Cable (or | |
| USB cable). (Refer to page 13, 14 for connection.) |
2 | Turn a projector on first, and then turn on your computer. When |
computer is switched on first, Wireless Mouse may not work |
properly.
Note : When your computer has no mouse port, connect Serial Port of your computer to Control Port of a projector with Control Cable for Serial Port (not supplied).
OPERATING WIRELESS MOUSE
When controlling a PC mouse pointer, operate Wireless Mouse with POINT button, SELECT button, and RIGHT CLICK button on Wireless Remote Control Unit.
POINT button | POINT button (Move pointer) |
Used to move PC mouse pointer. Pointer is moved corresponding with direction you are pressing.
SELECT (LEFT CLICK) button
This button has same function as left button in a PC mouse.
RIGHT CLICK button
This button has same function as right button in a PC mouse. This button is not available for controlling this projector.
SELECT button | RIGHT CLICK button |
(left button of mouse) | (right button of mouse) |
MAINTENANCE
WARNING TEMP. INDICATOR
WARNING TEMP. Indicator flashes red and projector is automatically turned off when an internal temperature of a projector exceeds normal temperature. Wait at least 5 minutes before turning on projector again.
When WARNING TEMP. Indicator continues to flash, check items listed below.
1 | Ventilation Slots of a projector may be blocked. In such an event, reposition a projector so that Ventilation Slots are |
not obstructed. | |
2 | Air Filter may be clogged with dust particles. Clean Air Filter by following section AIR FILTER CARE AND CLEANING |
on next page. | |
3 | If WARNING TEMP. Indicator remains on after performing above checks, Cooling Fans or Internal Circuits may be |
malfunctioning. Contact service personnel from an authorized dealer or a service station. |
42