Compaq MP1400 manual Solving Lamp Problems, Lamp shuts off

Solving Lamp Problems

Lamp shuts off	1. If all five projector panel buttons
	flash amber, the projector has
	overheated and will automatically
	shut down. Wait 5-10 minutes
	until the buttons stop flashing
	and the Standby button turns
	amber before restarting the
	projector again.
	2. A minor power surge may cause
	the lamp to shut off. Turn the
	projector off. Wait a few minutes,
	then turn it back on.
Lamp burns out or makes a	When the lamp reaches its end of life,
popping sound	it will burn out and may make a loud
	popping sound. If this happens, the
	projector will not turn back on until
	the lamp module has been replaced.
	For information on purchasing a
	replacement lamp module, call your
	Compaq authorized dealer, seller, or
	reseller. To locate a reseller near you,
	call 1-800-AT-COMPAQ. To purchase
	directly from Compaq, visit the
	Compaq web site at
	http://www.compaq.com/products/
	projectors.
	To replace the lamp, follow the
	procedures in the “ Replacing the
	Projector Lamp Module” section in
	Chapter 5, “ Care and Maintenance.”

￿￿

Troubleshooting A-5