TURNING OFF THE POWER
|
|
| STANDBY/ON |
VIDEO | RGB | SEARCH |
|
ASPECT |
| AUTO | BLANK |
MAGNIFY | HOME | PAGE UP | VOLUME |
ON |
|
|
|
| END | PAGE DOWN | MUTE |
OFF |
|
|
|
FREEZE |
| KEYSTONE | |
POSITION |
|
| MENU |
| ENTER |
| |
ESC |
|
| RESET |
Control panel
LANP
TENP
POWER
STANDBY/ON INPUT KEYSTONE RESET
NOTE
•Except in emergencies, follow the above- mentioned procedure for turning power off.
1Press the STANDBY/ON button (control panel or remote control)
The message "Power off?" will appear on the screen for approximately 5 seconds.
STANDBY/ON
2Press the STANDBY/ON button again (control panel or remote control)
Press the STANDBY/ON button again while the "Power off?" message is visible. The projector lamp goes off and starts cooling down. The POWER indicator blinks orange while the lamp cools down. (Pressing the STANDBY/ON button while the POWER indicator is blinking orange has no effect.)
The system goes into the STANDBY mode after cooling down and the POWER indicator stops blinking orange and then lights to solid orange.
STANDBY/ON
3Check that the POWER indicator stops
blinking and lights to solid power switch
orange.
Switch the power switch to [O] (OFF).
POWER indicator
BY/
PUT
YSTONE
RESET
KEYSTONE |
|
| LANP |
PO | WER | TENP | |
| RESET |
| |
|
|
|
4Confirm that the POWER indicator has gone off and then attach the lens cap.
When the projector has completed powering down, the POWER indicator will go off.
16