BOXLIGHT CP-13t Remote Control Unit, Does not work, Wireless Mouse, Function does not, Work, Card

APPENDIX

Problem:	Try these Solution
Remote Control Unit	● Check the batteries.
does not work.	● Check the ALL-OFF switch on the Remote Control Unit is set to “ON.”.
	● Make sure anything is blocking between the Remote Receiver and the Remote Control
	Unit.
	● Make sure you are not too far from the projector when using the Remote Control Unit.
	Maximum operating range is 16.4’ (5m).
Wireless Mouse	● Check the cable connection between the projector and the computer.
function does not	● Check the mouse setting on your computer.
	● Turn the projector before your turn on the computer.
work.
The image data in	● Check the memory card is inserted properly into PC CARD SLOT.
memory card isn’t	● Check SmartMedia or PC Card Adapter is set properly.
	● Check MCI mode is selected.
displayed.
	● Check the image data is recorded in the memory card properly.
	● Start the projector again.
The image data can’t	● Check the projector is turned on.
be written in, read	● Check “Card access” in VIEW menu is selected.
	● Check Control Cable for Serial Port (optional) is connected properly.
from the memory
	● Check the memory card is inserted properly into PC CARD SLOT.
card.
	● Check Media Card Imager (supplied) is installed in your computer properly.
	● Check the setting in Media Card Imager (like Serial Port Setting) is set properly.

WARNING :

High voltages are used to operate this projector. Do not attempt to open the cabinet.

Boxlight Service is easily obtained. If after all operating instructions above, you find that service is necessary, contact Boxlight for assistance at 1-800-762-5757 or 360-779-7901.

Give the model number and explain the difficulty. We will advise you how to obtain service.

45