Onkyo A-9555, A-9755* instruction manual Front & Rear Panels

Front & Rear Panels—Continued

Rear Panel

1 2

6 7 8 90AB C

(A-9755 only)

AGrounding terminal

This terminal is for connecting a turntable’s ground wire.

BPHONO (MM) input

This analog audio input is for connecting a turntable with a moving-magnet cartridge.

CSPEAKERS A

These terminal posts are for connecting speaker set A.

DSPEAKERS B

These terminal posts are for connecting speaker set B.

EAC INLET

This connector is for connecting the supplied power cord (see page 5).

FCD input

This analog audio input is for connecting a CD player’s analog audio output.

GTUNER input

This analog audio input is for connecting a tuner’s analog audio output.

HTAPE IN/OUT

This analog audio input and output are for connect- ing a cassette deck with an analog audio input and output.

IMD IN/OUT

This analog audio input and output are for connect- ing an MD recorder with an analog audio input and output.

JHDD IN

This analog audio input is for connecting a compo- nent’s analog audio output (RI Dock, etc.).

3 4 5

This illustration is for A-9755.

KLINE input

This analog audio input is for connecting a compo- nent’s analog audio output (TV, etc.).

LMAIN IN (A-9755 only)

This analog audio input is for connecting a separate preamp when you want to use the A-9755 as a power amplifier.

Caution:

Do not connect a component that does not have an output volume control, such as a CD player, because the sound will be output at maximum vol- ume and may damage the A-9755 and your speak- ers.

M REMOTE CONTROL jacks

These (Remote Interactive) jacks can be con-

nected to the jacks on your other Onkyo audio components. The A-9755/A-9555’s remote control- ler can then be used to control all of your compo-

nents. To use , you must make an analog audio connection between the A-9755/A-9555 and each component.

See pages 10–13 for connection information.

7