Shutting down the projector
The projector automatically blanks the screen after no active source is detected for 30 minutes. This blank screen helps preserve the life of the pro- jector. The image returns when an active source is detected or a remote or keypad button is pressed.
Screen Save
You can make the blank screen appear after five minutes by turning on Screen Save in the Settings>System menu. See page 29. There are six time options for the Screen Save feature. They range from five minutes to 30 min- utes with five minute intervals.
Power Save
The projector also has a Power Save feature that automatically turns the lamp off after no signal is detected for 20 minutes. After 10 additional min- utes with no signal, the projector powers down. If an active signal is received before the projector powers down, the image is displayed. You must press the Power button to display an image after 30 minutes have passed. When Power Save is enabled, Screen Save is disabled. See page 29.
Turning off the projector
To turn off the projector, press the Power button and verify that you want to turn the projector off by pressing the Power button again within 3 seconds. You can cancel the shutdown by not pressing the Power button a second time. The lamp turns off and the LED blinks amber for 1 minute while the fans continue to run to cool the lamp. When the lamp has cooled, the LED lights amber and the fans stop. Unplug the power cable to completely power off the projector.
Troubleshooting your setup
If your image appears correctly on the screen, skip to the next section (page 21). If it does not, troubleshoot the setup.
The Status Indicator Panel on top of the projector indicates the state of the projector and can help you troubleshoot.
.
Table 1: Status indicator light behavior and meaning
Status Indicator Panel Symbols | Meaning | |
|
| |
Power, solid amber | The projector is plugged in. | |
Power, blinking green | The power button has been pressed and | |
the software is initializing. | ||
| ||
Power, solid green | The projector is on and initialized. | |
| ||
Power, blinking amber | The power button has been pressed twice | |
to turn the projector off and the fans are | ||
| ||
| running to cool the projector. | |
|
| |
Thermometer | The projector is too hot. Make sure the | |
| vents aren’t blocked (see page 19). Turn | |
| off the projector and wait one minute, | |
| then turn the projector on again. Contact | |
| Technical Support if the problem persists. | |
|
| |
Lamp | Turn off the projector and wait one | |
| minute, then turn the projector on again. | |
| If the lamp light turns on again, replace the | |
| lamp and reset the lamp timer. | |
|
| |
Wrench/Service | Turn off the projector and wait one | |
| minute, then turn the projector on again. | |
| If the service lamp turns on again, service | |
| is required. Visit www.infocus.com/service | |
| to contact Service. | |
|
|
12