Personalizing the projector menu display
The
•Menu Display Time in the SYSTEM SETUP: Basic > Menu Settings menu sets the length of time the OSD will remain active after your last button press. The time length
ranges from 5 to 30 seconds in 
Left/ 
Right to select a suitable time.
•Menu Position in the SYSTEM SETUP: Basic > Menu Settings menu sets the OSD position in five locations. Use 
Left/ 
Right to select a preferred position.
•Language in the SYSTEM SETUP: Basic menu sets your familiar language for the On- Screen (OSD) Menus. Use 
Left/ 
Right to select your language.
•Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo screen to be displayed during projector 
Left/ 
Right to select a screen.
Shutting down the projector
1. | Press |
| II |
| Power and a confirmation |
| message will display prompting you. | ||||
| If you don't respond in a few seconds, | ||||
| the message will disappear. | ||||
|
|
|
| ||
2. | Press |
| II | Power a second time. The | |
Power indicator light flashes orange, the projection lamp shuts down, and the fans will continue to run for approximately 90 seconds to cool down the projector.
To protect the lamp, the projector will not respond to any commands during the cooling process.
3.The Power indicator light is a steady orange once the cooling process has finished and fans stop.
4.Disconnect the power cord from the wall socket.
To save your time, you can unplug the projector as soon as it is turned off without waiting for the cooling time. The projector will continue cooling down even if it is unplugged so that you can pack up the projector and go. During the projector's