Using the projector and remote control
Preparations
1.Turn all of the connected equipment on.
2.Remove the lens cap.
3.Plug the supplied power cord into the AC inlet on the rear of the projector.
4.Plug the power cord into a wall socket and turn the wall switch on.
Turning the power on
1.Check that the Power indicator lights orange after power has been applied.
2. Press and hold the Power button on the projector or remote control to turn the projector on. The Power indicator light flashes for about 30 seconds during warm up, then remains constantly on (and the projector starts projecting) when ready.
3. Press Source on the projector or one of the Source buttons on the remote control to select your desired input signal. A message shows on the screen when the port is being searched.
If you would like to change the input signal, please see below.
Switching input signals
To sequentially select input signals, press one of the Source buttons on the remote control or Source on the projector.
The selected source will be displayed at the bottom right of the screen for 3 seconds.
Activate the Source Scan function in the Advance menu if you want the projector to automatically search input ports. It may take a few seconds for the projector to search for input signals.
Adjusting the image
Adjusting the angle height
The projector is equipped with 1 front
1. Lift the projector up and press the adjuster button to release the adjuster. The front adjuster foot will drop into position and lock into place when you release the button. It can lift the projector by
up to 15 degrees. Manually screw it up or down for fine height adjustment.
2.Screw the rear adjuster feet to adjust the horizontal angle so that the projector is stable and the projection is level.
Using the projector and remote control | 15 |