Acer K10 manual Remarque à lintention des utilisateurs canadiens

Page 36

English

24

Remarque à l'intention des utilisateurs canadiens

Cet appareil numérique de la classe B est conforme a la norme NMB-003 du Canada.

Canada — Low-power license-exempt radio communication devices (RSS-210)

aCommon information

Operation is subject to the following two conditions:

1.This device may not cause interference, and

2.This device must accept any interference, including interference that may cause undesired operation of the device.

bOperation in 2.4 GHz band

To prevent radio interference to the licensed service, this device is intended to be operated indoors and installation outdoors is subject to licensing.

Declaration of Conformity for EU countries

Acer hereby declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.

Compliant with Russian regulatory certification

Radio device regulatory notice

Note: Below regulatory information is for models with wireless LAN and/or Bluetooth only.

General

This product complies with the radio frequency and safety standards of any country or region in which it has been approved for wireless use. Depending on configurations, this product may or may not contain wireless radio devices (such as wireless LAN and/or Bluetooth modules). Below information is for products with such devices.

Page 35 Page 37
Image 36
Page 35 Page 37
Contents Acer Projector K10 Users Guide Page Information for your safety and comfort Turning the product off before cleaningUsing electrical power Additional safety information Product servicingOperating environment for using wireless optional Medical devicesVehicles Potentially explosive environmentsHearing Protection Disposal instructionsPrecautions Usage NotesPage Contents Page Product Features IntroductionContents Projector Overview Projector OutlookFront / upper side Rear sideControl Panel Function DescriptionConnecting the Projector Getting StartedTurning the Projector On/Off Turning On the ProjectorTurning Off the Projector Projector Overheated. Lamp will automatically turn off soonAdjusting the Height of Projected Image To raise the imageTo lower the image How to Optimize Image Size and Distance Figure Fixed distance with optimal screen sizeImage cm Using the OSD menus Onscreen Display OSD MenusColor Setting Display ModeImage Setting TintEnglish Management Setting Language SettingTroubleshooting Image Problems and SolutionsEnglish Problems with the Projector OSD MessagesLED & Alarm Definition Listing LED MessagesSpecifications Ntsc M/4.43, PAL B/D/G/H/I/M/N, SECAM, HdtvCompatibility Modes VGA AnalogVGA Analog Hdtv Signal FCC Notice Operation conditionsRemarque à lintention des utilisateurs canadiens Declaration of Conformity for EU countriesEuropean Union EU List of applicable countriesFederal Communications Commission Declaration of Conformity Declaration of Conformity
Top Page Image Contents